Specification：
Moreover, our PP Compression Fitting has an optimum sealing which works under all the conditions.
With an adequate combination of these fittings it is possible to design and pressure piping application of fluide with PE pipes
Referenced Standards: EN ISO1587 ; AS/NZS4129
You should slide the nut on the pipe and after that place the compression ring. Next, all that is left is to slide the pipe directly into the fitting and make sure that the nut is tightened as required.

Main Products：

PP pipe non-toxic, health, high temperature resistant and recyclable, mainly used in buildings indoor hot and cold water supply system, also widely used in heating system.

characteristic

◇ No corrosion: PP tubes can withstand corrosion of high concentrations of acid and base in a wide range of PH values, ranging from 1 to 14.

◇ Wear resistance and no scaling: The inner wall of PP pipe and fittings is smooth, with low flow resistance and no scaling.

Reduce vibration and noise: PP tube has excellent sound insulation performance, can significantly reduce the vibration and noise caused by liquid flow.

◇ Anti-freezing and cracking: PP material has excellent elasticity so that the section of pipe and pipe fitting can be expanded with the liquid of frost swelling without swelling and cracking.

Anti condensation, less heat loss: PP material is a bad heat conductor, can reduce condensation phenomenon and reduce heat loss.

Simple installation: PP tube is light in weight, easy to install and operate, and has weldability.

◇ Long service life: the life of PP tube system can reach 50 years under the specified service conditions.