ERA Piping Systems, PP Compression Fitting Valves & Filters , PP Compression Disc Filter , FLT6014 , WRAS

Features：
The compression fittings for HDPE pipe are made by high quality PP material with UV protection, both material and fittings are approved use with drinking water.
PP Compression Fittings is fabricated and designed using premium quality basic material and progressive technology.
Our company is one of the great manufacturers from all around the world.
The high-quality material used in the product has an application in the area of water distribution, irrigation, swimming pools, and cable conduits.

Specification：
Moreover, our PP Compression Fitting has an optimum sealing which works under all the conditions.
With an adequate combination of these fittings it is possible to design and pressure piping application of fluide with PE pipes
Referenced Standards: EN ISO1587 ; AS/NZS4129
You should slide the nut on the pipe and after that place the compression ring. Next, all that is left is to slide the pipe directly into the fitting and make sure that the nut is tightened as required.

introduction

Polypropylene, a kind of plastic, is a high density, no side chain, high crystallization of linear polymer, with excellent comprehensive properties. Common products: basin, bucket, furniture, film, woven bag, bottle caps, car bumper, etc.

pp plastic, chemical name :Polypropylene English name :Polypropylene (pp for short) proportion :0.9-0.91 g/cubic centimeter forming shrinkage rate :1.0-2.5% molding temperature: 160-220℃PP is a crystalline polymer, PP's comprehensive performance is better than PE material. PP products light weight, good toughness, good chemical resistance. The disadvantages of PP: low dimensional accuracy, insufficient rigidity, poor weather resistance, it has a shrinkage phenomenon, after stripping, easy aging, brittle, easy deformation. In daily life, the commonly used crisper is made of PP material.

Heat resistance

PP polyester is a kind of amorphous, its melting point should be more than 220, its thermal deformation temperature should be about 121 degrees, but because it is a large molecular polymer, the higher the temperature of small analysis oligomer precipitation possibility is greater, and these substances are not conducive to human health, and according to the customer use, the general boiling water 100 degrees, so the general plastic cup is not It will mark anything over 100 degrees.